Course catalogue

LEARNING OBJECTIVES

By the end of the course the participants should:

• Have acquired knowledge of the latest rules and regulations
• Have acquired knowledge of the latest developments within sensors and Position Reference Systems (PRS)
• Have acquired knowledge of the latest relevant DP incidents and why they occurred
• Be able to recognize the various alarm, warning and information messages
• Carry out operational planning, risk assessment and hazard identification tasks
• Set up the DP system for a particular task/ operation
• Decide on courses of action because of system failure

CONTENT

The course is conducted as classroom training, combining theoretical presentation (Show-and Tell Lessons) and practical work/discussion with exercises in simulator and guidance (Stair-Step learning design). For practical capabilities and skills, exercises are performed in full equipped DP simulator. This course will fulfil the revalidation learning objectives as specified by Nautical institute.

SPECIAL INFORMATION

At present (2016), the requiremets is that the holder of a Nautical Institute (NI) DPO certificate must revalidate their DPO certificates.

The requirement is that the DPO must have at least 150 days of DP sea time experience in the previous 5 years, if not NI DPO Revalidation course is needed.

CERTIFICATE

A certificate acceditated by the Nautical Institute will be issued on succcessful completion of the course.

LEARNING OBJECTIVES

After the course, the successful participants are able to:

• Define the principles of DP
• Recognise the component parts of a DP system
• Understand the relationship between vessel movement  position reference systems, sensors, computers propulsion units and feedback
• Understand the concept of redundancy
• Understand the DP modes of control
• Describe the operation of sensors and common position reference systems
• Describe propulsion units, types and configurations
• Understand power supply, redundancy and management
• Practice communication and watch handover procedures

CONTENT

• Definition of DP, elements of the DP system, DP systems redundancy, and Class Requirements
• Functions of the DP system, and DP principles
• Different types of DP vessels and DP operations, sensors and use of sensor inputs
• Introduction to position reference systems and the DP system’s use of position measurements
• Vessel capability, DP consequence analysis and DP capability analysis
• Thrusters and manoeuvring systems
• Power systems and Blackout Prevention
• Operational procedures for DP operation, and procedures for operating the DP system
• Study of DP incidents
• Principal use of the DP system

LEARNING PROCESS

The training will be a combination of theoretical lessons and practical exercises. During the course each participant will have his own operator station with generic DP software.

SPECIAL INFORMATION

The DP Induction course is the first phase of the Nautical Institute (NI) DP Operator Certification Scheme. The course participants will be issued with the NI Dynamic Positioning Operator’s Log Book upon successful completion of the DP Induction Course.

This course is according to the system specific competence requirements in IMO STCW Regulations I/14 1.5, Part A-I/14 2.1.1, part B V/f 6 and IMCA M117.

CERTIFICATE

A certificate accreditated by the Nautical Institute will be issued on succcessful completion of the course.

LEARNING OBJECTIVES

This course is specifically designed for training future DPO’s on board a large number of offshore vessels.

The course aim to provide the candidates with knowledge and skills as preparation for DNV DPO Advanced Operations exams and certification.

By the end of course the students shall have:

• Acquired a thorough knowledge of the various types of DP operations such as ROV operations, cable laying pipe laying, trenching, dredging and rock-dumping
• The capability to operate the DP in the various modes associated with such operations, i.e. joystick,  auto pos mode, autotrack mode and follow target mode
• Recognize when environmental conditions or system failure  requires DPO to take action to avoid hazardous situations
• The  ability to carry out such operations according to existing operational guidelines and checklists
• The ability  to demonstrate good personal attitudes towards safety in operating DP vessels according to best practice in the industry

CONTENT

Planning,  briefing and de-briefing of various field exercises according to the existing guidelines, regulations, and industry standards. Repetition of necessary DP theory to close any knowledge gap the students may have in these subjects.

LEARNING PROCESS

All DP  exercises will be carried out on a full scale DNV GL Approved DP Class A simulator, using vessels that are equipped according to DP class 2 and 3. The participants will perform both surface and subsea  operations, utilizing the following DP modes: Joystick, Autoposition, Autotrack and Follow target functionalities.

SPECIAL INFORMATION

• DNV GL, Standard for Certification no. 0023
• DNV GL, Standard for Certification no. 0008
• DNV GL, RP-0007
• NMA 201209765-4/813.4.
• GOMO, Guidelines for offshore marine operations, Supply and Rig Move Operations and other relevant guidelines such as IMCA M-117 and other IMCA guidelines

A level test will be conducted before commencing the course.

CERTIFICATE

Certification of attendance will be issued upon successful completion of the course.

Når kurset er fullført, skal deltakerene være i stand til å klargjøre livbåten, organisere ombordstigning, låre og frigjøre båten, manøvrere og lede operasjonen av livbåten på vannet. 

Regelverk / ansvarsforhold 

Utsetning- systemer for skip og rigg 

Nødkommunikasjon og aktuelt utstyr 

Utstyr i båt og flåte 

Livreddende førstehjelp 

Prosedyrer / alarminstruks 

Kommandoforhold / samarbeid 

Personlig vern og utstyr 

Praktisk øvelse under aktuelle båttype 

Opphold i båt 

Berge opp folk fra sjøen 

Snu en kantret redningsflåte iført redningsvest

Førstehjelp

With COVID-19 meaning that home working is no longer an option but a necessity for many, what are the potential side effects on our health and work performance. Employers may need to provide additional training to ensure appropriate supervision and work behaviours. These include remote technology, communication skills development, time management and ergonomics.

Effective remote working requires greater self-control and discipline to avoid the boundaries between work and personal life becoming blurred. Research has shown that, in general, homeworkers tend to work longer than office workers and this increases with the use of technology. Homeworkers do benefit from greater working time autonomy, but how effectively this is applied depends on the discipline of the individual.

The ‘Effective Remote Working’ bundle includes 3 months access to 10 online courses and over 7 hours of eLearning.  

• Management of Change

• Lone Working (Employees)

• Smart Workplaces: Responsible Social Media for Team members

• Business Writing: E-Mail Techniques

• AEC Success: Effective Decision Making

• Webinars – Conducting a Web-based Presentation

• ABCs of Managing Time & Effort: The 80/20 Way

• Smart Time Management: 7 Steps to Regaining Control of Your Day

• 3-way Communication

• Smart Customer Service 3: Effective Verbal and Nonverbal Communication